DOWNLOAD MAKERBOT 2X FIRMWARE

Refer to the documentation you received with the printer. You will see different printers listed, including those listed below. The Sailfish firmware is a derivative of version 3. Make sure that you see the USB port for your printer listed. Proceed to the next section for instructions on configuring Sailfish for your printer. Also, when you click on a given version, any specific requirements for that version will be listed on the right hand side. You do need to be connected to the Internet in order for the download to succeed.

Uploader:	Mikale
Date Added:	11 June 2007
File Size:	60.4 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	84092
Price:	Free* [*Free Regsitration Required]

Make sure that you see the USB port for your printer listed. On Windows systems, just unzip the ReplicatorG download fidmware place the folder on your desktop. Once the firmware has successfully downloaded, you are ready to configure Sailfish!

If you do not have MakerWare or Desktop, then download it from makerbot. You only need ReplicatorG to install or update Sailfish.

For the Replicator 2 and 2X, there is no mechanical reset button and thus no need to press one. Thing-o-Matic owners should complete this step before beginning the next step. If you do not see your printer type listed, then select the printer for which 22x is a clone — often the Replicator 1.

Note that new printers are added when needed. Next, power your printer on — but do not connect from ReplicatorG to the printer.

You will see different printers listed, including those listed below. The X, Y, and Z home offsets.

Refer to the documentation you received with the printer. However, do not do so until you have completely finished installing figmware configuring Sailfish.

After running MakerWare as per the prior section, you must stop Conveyor. For other printers, skip to the next section. The Sailfish firmware is a derivative of version 3.

Makerbot Replicator 2 Firmware

Sailfish download location After a brief pause, ReplicatorG should start logging the firmware files it downloads; e. You do not need to use ReplicatorG as your slicer: Unless you have cause to do otherwise, select the most recent version majerbot the highest numbered one. Using MakerWare, write down the following machine onboard parameters: To stop Conveyor, first launch MakerWare if it is not already running. Then, as you install Sailfish, carefully reread and follow each step.

Otherwise, Conveyor will prevent ReplicatorG from downloading firmware to your printer. Then run the replicatorg.

Makerbot Replicator 2 Firmware

Also, when you click on a given version, any specific requirements for that version will be listed on the right hand side. After makerot have installed Sailfish, you can restart Conveyor if you wish. For most other printers, there may be one and you may need to press it. You do need to be connected to the Internet in order for the download to succeed.

Then select the USB port to which your printer is connected. Proceed to the next section for instructions on configuring Sailfish for your printer.

Typically this includes the recommended revision of ReplicatorG. When having to press a reset button, the timing can be tricky and frustrating, especially on Windows systems. You should then see different firmware versions listed.

If your printer has two extruders, write down the X and Y toolhead offsets. Note that using a firewall proxy will probably not be successful.